Oil Level Inspection; Oil Filter Replacement - Suzuki GSX-R1000 Service Manual

Manuals by Motomatrix / The Solution For Lost Motorcycle Coded Keys
0B-11 Maintenance and Lubrication:
7) Hold the motorcycle vertically and check the oil level
through the inspection window (3). The oil level
should be between the low level "L" and full level "F".
F
L

Oil Level Inspection

1) Place the motorcycle on the side-stand.
2) Start up the engine and allow it to run for several
minutes at idle speed.
3) Turn off the engine and wait about three minutes.
4) Hold the motorcycle vertically and check the oil level
through the inspection window (1). The oil level
should be between the low level "L" and full level "F".
F
L

Oil Filter Replacement

1) Remove the right side cowling. Refer to "Exterior
Parts Removal and Installation" in Section 9D
(Page 9D-6).
2) Drain engine oil as described in the engine oil
replacement procedure.
3) Remove the oil filter (1) using the special tool.
Special tool
(A): 09915–40610 (Oil filter wrench)
1
email: info@motomatrix.co.uk / www.motomatrix.co.uk
4) Apply engine oil lightly to the O-ring of new oil filter,
3
I815H1020023-01
5) Install new oil filter. Turn it by hand until you feel that
1
I815H1020024-01
6) Add new engine oil and check the oil level is as
(A)
I947H1020012-01
before installation.
CAUTION
!
ONLY USE A GENUINE SUZUKI
MOTORCYCLE OIL FILTER.
Other manufacturer's oil filters may differ in
thread specifications (thread diameter and
pitch), filtering performance and durability
which may lead to engine damage or oil
leaks. Also, do not use a genuine Suzuki
automobile oil filter on this motorcycle.
the oil filter O-ring contacts the oil filter mounting
surface. Then, tighten the oil filter two full turns (or to
specified torque) using the special tool.
NOTE
To properly tighten the oil filter, use the
special tool. Never tighten the oil filter by
hand only.
Special tool
(A): 09915–40610 (Oil filter wrench)
Tightening torque
Oil filter (a): 20 N·m (2.0 kgf-m, 14.5 lbf-ft)
(a)
described in the engine oil replacement procedure.
Necessary amount of engine oil
Oil change: 2 800 ml (3.0/2.5 US/lmp qt)
Oil and filter change: 3 300 ml (3.5/3.0 US/lmp qt)
Engine overhaul: 3 600 ml (2.8/3.2 US/lmp qt)
(A)
I823H1020041-01