No Spark Or Poor Spark - Suzuki GSX-R1000 Service Manual

Hide thumbs Also See for GSX-R1000:
Table of Contents

Advertisement

Manuals by Motomatrix / The Solution For Lost Motorcycle Coded Keys
1H-5 Ignition System:

No Spark or Poor Spark

Troubleshooting
NOTE
Check that the transmission is in neutral and the engine stop switch is in the "RUN" position. Grasp
the clutch lever. Check that the fuse is not blown and the battery is fully-charged before diagnosing.
Step
1
Check the ignition system couplers for poor connections.
Is there connection in the ignition system couplers?
2
Measure the battery voltage between input lead wires at the
ECM with the ignition switch in the "ON" position. (E-02, 19,
24, 51: O/G and B/W, E-03, 14, 28, 33: O/W and B/W)
Is the voltage OK?
3
Measure the ignition coil primary peak voltage. Refer to
"Ignition Coil Inspection" (Page 1H-7).
NOTE
This inspection method is applicable only with
the multi-circuit tester and the peak volt adaptor.
Is the peak voltage OK?
4
Inspect the spark plugs. Refer to "Spark Plug Inspection and
Cleaning" in Section 0B (Page 0B-9).
Is the spark plug(-s) OK?
5
Inspect the ignition coil. Refer to "Ignition Coil Inspection"
(Page 1H-7).
Is the ignition coil OK?
6
Measure the CKP sensor peak voltage and its resistance.
Refer to "CKP Sensor Inspection" (Page 1H-9).
NOTE
The CKP sensor peak voltage inspection is
applicable only with the multi-circuit tester and
peak volt adaptor.
Are the peak voltage and resistance OK?
email: info@motomatrix.co.uk / www.motomatrix.co.uk
Action
Yes
Go to Step 2.
Poor connection of
couplers.
Go to Step 3.
• Faulty ignition switch.
• Faulty turn signal/
• Faulty engine stop
• Broken wire harness
Go to Step 4.
Go to Step 5.
Go to Step 5.
Faulty spark plug(-s).
Go to Step 6.
• Faulty ignition coil.
• Poor connection of
• Faulty ECM.
• Faulty CKP sensor.
• Open or short circuit
• Metal particles or
in wire harness.
• Poor connection of
ignition couplers.
B947H11804002
No
side-stand relay.
switch.
or poor connection of
related circuit
couplers.
the ignition coil.
foreign material being
stuck on the CKP
sensor and rotor tip.

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents