Suzuki GSX-R1000 Service Manual page 457

Manuals by Motomatrix / The Solution For Lost Motorcycle Coded Keys
4) Remove the cushion lever bearing (3) using the
special tool.
Special tool
(A): 09921–20240 (Bearing remover set)
Installation
CAUTION
!
The removed bearings must be replaced with
new ones.
1) Install the center spacer.
2) Press the pivot bearings into the swingarm pivot to
the depth "a" of 0 – 0.5 mm (0 – 0.02 in) from the
edge with the special tool and suitable size socket
wrench.
NOTE
When installing the bearing, stamped mark
on the bearing must face outside and apply a
small quantity of the grease to housing.
: Grease 99000–25010 (SUZUKI SUPER
GREASE "A" or equivalent)
Special tool
(A): 09941–34513 (Bearing installer)
"a": 0 – 0.5 mm (0 – 0.02 in)
email: info@motomatrix.co.uk / www.motomatrix.co.uk
(A)
3
I947H1230053-01
" a "
(A)
I947H1230054-02
3) Press the cushion lever bearing into the swingarm to
the depth "b" of 1.5 mm (0.06 in) from the edge with
the special tool and suitable size socket wrench.
NOTE
Apply a small quantity of the grease to
housing when installing the bearing.
: Grease 99000–25010 (SUZUKI SUPER
GREASE "A" or equivalent)
Special tool
(B): 09924–84521 (Bearing installer set)
" b "
"b": 1.5 mm (0.06 in)
4) Apply grease to the bearings.
: Grease 99000–25010 (SUZUKI SUPER
GREASE "A" or equivalent)
5) Install the swingarm. Refer to "Swingarm Removal
and Installation" (Page 2C-9).
Rear Suspension: 2C-14
(B)
I947H1230055-02
I947H1230056-01
I947H1230057-01