Water Hose Inspection - Suzuki GSX-R1000 Service Manual

Manuals by Motomatrix / The Solution For Lost Motorcycle Coded Keys
1F-7 Engine Cooling System:
7) Remove the oil cooler (6) from the bracket.
6
8) Remove the radiator assembly by removing the
bolts.
9) Remove the radiator outlet hose (7) and cooling fan
motor (8) from the radiator.
7
email: info@motomatrix.co.uk / www.motomatrix.co.uk
Installation
Install the radiator in the reverse order of removal. Pay
attention to the following points:
• Install the radiator and oil cooler to their bracket. Refer
to "Radiator Inspection and Cleaning" (Page 1F-5).
• Apply thread lock to the reservoir tank bolt and tighten
it securely.
(THREAD LOCK CEMENT SUPER "1322" or
equivalent)
I947H1160010-01
• Connect the radiator hoses securely. Refer to "Water
Hose Routing Diagram" (Page 1F-3).
• Pour engine coolant. Refer to "Cooling System
Inspection" in Section 0B (Page 0B-12).
I947H1160011-01
• Bleed air from the cooling circuit. Refer to "Cooling
System Inspection" in Section 0B (Page 0B-12).

Water Hose Inspection

Inspect the water hoses in the following procedures:
1) Remove the side cowlings. Refer to "Exterior Parts
Removal and Installation" in Section 9D (Page 9D-
6).
2) Check the water hoses for crack, damage or engine
coolant leakage. If any defect is found, replace the
water hose with a new one.
I947H1160012-02
8
I947H1160013-01
: Thread lock cement 99000–32110
I947H1160058-01
B947H11606005