Suzuki GSX-R1000 Service Manual page 294

Manuals by Motomatrix / The Solution For Lost Motorcycle Coded Keys
1D-60 Engine Mechanical:
2) Position the No. 2 and No. 3 conrod big ends on the
same side, and the No. 1 and No. 4 conrod big ends
on the opposite side of No. 2 and No. 3.
3) Set the crankshaft onto the conrods and upper
crankcase.
4) Apply molybdenum oil to each crank pin and bearing
surface.
CAUTION
!
Be sure to clean the conrod big end.
M/O: Molybdenum oil (MOLYBDENUM OIL
SOLUTION)
5) When fitting the conrod cap, make sure that I.D.
code "A" on each conrod faces intake side.
email: info@motomatrix.co.uk / www.motomatrix.co.uk
6) Apply engine oil to the conrod cap bolts.
7) Tighten the conrod cap bolt by using a 10 mm, 12
point socket wrench in the following two steps.
I947H1140170-01
Tightening torque
Conrod cap bolt: 37 N⋅m (3.7 kgf-m, 26.5 lbf-ft)
then turn in 1/6 (60°) turn
I947H1140171-01
8) Apply engine oil to the conrod big end side surfaces.
9) Apply molybdenum oil to each crankshaft journal and
bearing lightly.
M/O: Molybdenum oil (MOLYBDENUM OIL
I947H1140172-01
SOLUTION)
"A"
" a "
"a": 60°
I947H1140173-01
I947H1140174-01
I947H1140175-01