Engine Stop Switch Inspection; Ckp Sensor Resistance; Ckp Sensor Removal And Installation - Suzuki GSX-R1000 Service Manual

Manuals by Motomatrix / The Solution For Lost Motorcycle Coded Keys
6) If the peak voltage is within the specification, check
the continuity between the CKP sensor coupler and
ECM coupler.
CAUTION
!
Normally, use the needle pointed probe to the
backside of the lead wire coupler to prevent
the terminal bend and terminal alignment.
7) After measuring the CKP sensor peak voltage,
connect the CKP sensor coupler.

CKP Sensor Resistance

1) Lift and support the fuel tank. Refer to "Fuel Tank
Removal and Installation" in Section 1G (Page 1G-
9).
2) Disconnect the CKP sensor coupler (1).
3) Measure the resistance between the lead wires and
ground. If the resistance is not within the standard
range, replace the CKP sensor with a new one.
Refer to "CKP Sensor Removal and Installation"
(Page 1H-10).
Tester knob indication
Resistance (Ω)
CKP sensor resistance
142 – 194 Ω (B – Bl/Y)
∞ Ω (B – Ground)
2
1. CKP sensor coupler
4) After measuring the CKP sensor resistance, connect
the CKP sensor coupler.
5) Reinstall the fuel tank. Refer to "Fuel Tank Removal
and Installation" in Section 1G (Page 1G-9).
email: info@motomatrix.co.uk / www.motomatrix.co.uk
1
I947H1180012-02
1
I837H1180011-01
2. CKP sensor

CKP Sensor Removal and Installation

Refer to "Generator Removal and Installation" in Section
1J (Page 1J-4).

Engine Stop Switch Inspection

Inspect the engine stop switch in the following
procedures:
1) Turn the ignition switch OFF.
2) Remove the air cleaner box. Refer to "Air Cleaner
Box Removal and Installation" in Section 1D
(Page 1D-7).
3) Disconnect the right handlebar switch coupler (1).
4) Inspect the engine stop switch for continuity with a
tester.
If any abnormality is found, replace the right
handlebar switch assembly with a new one. Refer to
"Handlebar Removal and Installation" in Section 6B
(Page 6B-2).
Special tool
: 09900–25008 (Multi circuit tester set)
Tester knob indication
Continuity ( )
Color
O/B
Position
( )
OFF
( )
RUN
5) After finishing the engine stop switch inspection,
reinstall the removed parts.
Ignition Switch Inspection
Refer to "Ignition Switch Inspection" in Section 9C
(Page 9C-7).
Ignition System: 1H-10
B947H11806005
B947H11806006
1
I947H1180013-01
O/W
I815H1180012-01
B947H11806007