Suzuki GSX-R1000 Service Manual page 565

Manuals by Motomatrix / The Solution For Lost Motorcycle Coded Keys
19) Tighten the clutch spring set bolts to the specified
torque.
Tightening torque
Clutch spring set bolt: 10 N·m (1.0 kgf-m, 7.0 lbf-
ft)
NOTE
Tighten the clutch spring set bolt little by
little and diagonally.
20) Loosen the lock-nut (24) and turn in the clutch
release adjusting screw (25) until resistance is felt.
21) From that position, turn out the clutch release
adjusting screw (25) 1 turn and tighten the lock-nut
(24) while holding the screw (25).
Tightening torque
Clutch release adjusting screw lock-nut: 6 N·m (
0.6 kgf-m, 4.5 lbf-ft)
24
email: info@motomatrix.co.uk / www.motomatrix.co.uk
I947H1530029-01
25
I947H1530030-02
22) Apply bond lightly to the mating surfaces at the
parting line between the upper and lower crankcases
as shown in the figure.
: Sealant 99000–31140 (SUZUKI BOND
No.1207B or equivalent)
23) Install the dowel pins and new gasket (26).
CAUTION
!
Use new gasket to prevent oil leakage.
26
24) Apply bond lightly to the CKP sensor grommet.
: Sealant 99000–31140 (SUZUKI BOND
No.1207B or equivalent)
25) Apply molybdenum oil solution to the starter torque
limiter/idle gear No. 2 shaft holes.
M/O: Molybdenum oil (MOLYBDENUM OIL
SOLUTION)
Clutch: 5C-10
I947H1530031-01
I947H1530032-01
I947H1530033-02