Manuals by Motomatrix / The Solution For Lost Motorcycle Coded Keys
Starter Button Inspection
Inspect the starter button in the following procedures:
1) Remove the air cleaner box. Refer to "Air Cleaner
Box Removal and Installation" in Section 1D
(Page 1D-7).
2) Disconnect the right handlebar switch coupler (1).
Service Data
Electrical
Unit: mm
Item
Starter motor brush length
Starter relay resistance
Tightening Torque Specifications
Fastening part
Starter motor housing bolt
Starter clutch bolt
NOTE
The specified tightening torque is described in the following.
"Starter Motor Components" (Page 1I-3)
Reference:
For the tightening torque of fastener not specified in this section, refer to "Tightening Torque List" in Section 0C
(Page 0C-9).
email: info@motomatrix.co.uk / www.motomatrix.co.uk
B947H11906011
1
I947H1190029-01
Specifications
Standard
Limit
N⋅m
5
54
3) Inspect the starter button for continuity with the
tester.
If any abnormality is found, replace the right handle
switch assembly with a new one. Refer to
"Handlebar Removal and Installation" in Section 6B
(Page 6B-2).
Special tool
: 09900–25008 (Multi circuit tester set)
Tester knob indication
Continuity (
)
Color
O/W
Position
PUSH
4) After finishing the starter button inspection, reinstall
the removed parts.
Specification
7.0 (0.28)
3.5 (0.14)
3 – 6 Ω
Tightening torque
kgf-m
lbf-ft
0.5
3.5
5.4
39.0
Starting System:
1I-12
Y/G
O/R
Y/W
I815H1190019-01
B947H11907001
Note
B947H11907002
Note
(Page 1I-5)
(Page 1I-11)