Oil Pump Inspection - Suzuki RMX450Z Service Manual

1E-6 Engine Lubrication System:
Installation
CAUTION
!
The removed snap ring must be replaced
with a new one.
• Install the pin (1) and inner rotor (2) to the oil pump
No. 2 shaft (3).
NOTE
Fit the groove "A" of the inner rotor onto the
pin (1).
"A"
• Apply engine oil to the oil pump No. 2 shaft (3) and
inner rotor (2) and install them.
• Apply engine oil to the outer rotor (4) and install it.
NOTE
Face the punch mark "B" to the crankcase
side.
3
2
3
2
1
IA02J1150016-01
"B"
4
IA02J1150017-02
• Install the oil pump No. 2 strainer (5) and snap ring
(6).
• Install the oil pump No. 2 (7) and tighten the oil pump
No. 2 bolts to the specified torque.
Tightening torque
Oil pump No. 2 bolt (a): 11 N·m (1.1 kgf-m, 8.0 lbf-
ft)
(a)
• Install the generator cover. Refer to "Generator
Removal and Installation" in Section 1J (Page 1J-5).

Oil Pump Inspection

Inspect the oil pump in the following procedures:
Oil Pump No. 1
1) Remove the oil pump No. 1. Refer to "Oil Pump No.
1 Removal and Installation" (Page 1E-3).
2) Inspect the oil pump parts for any defects or wear. If
any defects are found, replace the defective parts
with a new one.
6
5
IA02J1150018-01
7
IA02J1150019-01
BA02J21506010
IA02J1150020-01