Steering Column Jacket - Assemble - Off Vehicle - GMC chevrolet camaro 2000 Service Manual

)
Steering
5. Disassemble the steering column housing
assembly, if needed:
5.1. Remove the bearing assembly (12).
5.2. Remove the wire protector shield (9):
5.3. Remove the switch actuator rack (17) and
the rack preload spring (16).
5.4. Remove the drive shaft (8).
5.5. Remove the switch actuator sector (13).
5.6. Release the release lever pin (3) using
J22635.
5.7. Remove the shoe release lever (2).
5.8. Remove the release lever spring (4).
5.9. Remove the dowel pin (7).
5.10. Remove the steering wheel lock
shoes (10) and (11) using J 22635 and the
shoe springs (5).
5.11. Remove the bearing assembly (1 ).
Steering Column Jacket - Assemble - Off
Vehicle
Assembly Procedure
Tools Required
• J 38639 Steering Column Housing Bearing
Installer
• J 8092 Driver Handle
• J 22635 Lock Shoe and Release Lever Pin
Remover and Installer
1. To assemble the steering column housing
assembly if needed:
2. Install the bearing assembly (1)
3. Install the shoe springs (5).
4. Install the steering wheel lock shoes (1 O) and (11 ).
5. Install the dowel pin (7).
6. Install the release lever spring (4).
7. Install the shoe release lever (2).
8. Install the release lever pin (3) using J 22635.
9. Install the drive shaft (8).
10. Install the switch actuator sector (13).
11. Install the rack preload spring (16).
12. Install the switch actuator rack (17) to the switch
actuator sector (13).
13. Install the bearing assembly (12) using J 8092
and J 38639.
14. Install the wire protector shield (9).
Steering Wheel and Column - Tilt 2-85
12
~ /
354085
12
~ /
354085