GMC chevrolet camaro 2000 Service Manual page 660

Brakes
Antilock Brake System 5-187
DTC C0236 TCS RPM Signal Circuit Malfunction (cont'd)
)
Step
Action Value(s) Yes No
1. Reconnect all the connectors.
2. Using the scan tool clear the OTC.
8 3. Disconnect the scan tool from the DLC.
-
Go to A
4.
Start the engine.
Diagnostic
System
Did OTC C0236 reset?
Go to Step 10 Check-ABS
Replace the EBCM. Refer to
Electronic Brake Control
Go to
A
9
Module (EBCM) Replacement.
-
Diagnostic
-
Is the repair complete?
System
Check-ABS
Suspect PCM. Refer to
A Powertrain On Board
Go to
A
10
Diagnostic (080) System Check in Engine Controls.
-
Diagnostic
-
Is the repair complete?
System
Check-ABS
Repair an open in CKT 121 between 8120 and _the
Go to
A
11
EBCM harness connector terminal 11. Refer to Wiring
-
Diagnostic
-
Repairs.
System
Is the repair complete?
Check-ABS
Repair an open in CKT 121 between 8120 and the
Go to A
12
PCM harness connector C2 terminal 10. Refer to
Wiring
-
Diagnostic
-
Repairs.
System
Is the repair complete?
Check-ABS
Repair a short to ground in CKT 121. Refer to
Wiring
Go to
A
13
Repairs.
-
Diagnostic
-
Is the repair complete?
System_
Check-ABS
Repair a short to voltage in CKT 121. Refer to Wiring Go to A
14
Repairs.
-
Diagnostic
-
Is the repair complete?
System
Check-ABS
)
Replace all the terminals or replace the connectors that
exhibit signs of the following:
• That exhibit signs of poor terminal contact.
15
• That exhibit signs of corrosion.
-
-
• That exhibit signs of damaged terminals.
Go to
A
Diagnostic
Refer to
Connector Repairs
in Electrical Diagnosis.
System
Is the repair complete?
Check-ABS
)