Brake Caliper Bracket Replacement (Rear); Replacement (Front); Brake Rotor Replacement (Front) - GMC chevrolet camaro 2000 Service Manual

Brakes
Brake Caliper Bracket Replacement (Rear)
J
Removal Procedure
1. Remove the inner and outer brake pads, Refer to
Brake Pads Replacement (Rear).
Caution: These fasteners MUST be replaced with
new fasteners anytime they become loose or
are removed. Failure to replace these fasteners
after they become loose or are removed may cause
loss
of
vehicle control and personal injury.
2. Remove the caliper bracket bolts (2).
3. Remove the caliper bracket (1 ).
Installation Procedure
1. Lubricate the following components with silicone
grease:
• New bolt boots
• New bushings
2. Install the following components into the caliper
)
bracket (1):
• The bolt boots (2)
• The bushings
Notice: Refer to
Fastener Notice in Cautions and
Notices.
3. Install the caliper bracket with the bracket bolts.
Tighten
Tighten the caliper bolts to 100 N·m (74 lb ft).
4. Install the inner and outer brake pads. Refer to
Brake Pads Replacement (Rear).
Brake Rotor Replacement (Front)
Removal Procedure
1. Raise and suitably support the vehicle. Refer to
Lifting and Jacking the Vehicle in General
Information.
2. Remove the tire and the wheel. Refer to Tire and
Wheel Removal and Installation in Tires and
Wheels.
3. Remove the front brake caliper. Refer to Brake
Caliper Replacement (Front).
4. Remove the caliper mounting bracket bolts and
the caliper mounting bracket.
)
5. Remove the brake rotor (1) from the wheel ·
hub (2).
6. Clean the metal contact surfaces between the
brake rotor and the hub bearing flange.
Disc Brakes 5-..77
2
177036
2
177063
581489