GMC chevrolet camaro 2000 Service Manual page 515

5-42
Hydraulic Brakes
184635
Brakes
Installation Procedure
Notice: Refer to Fastener Notice in Cautions and (
Notices.
1. Install the brake hose (3) and the. brake hose
fitting bolt(8) to the rear axle
(4). ·
Tighten
Tighten the rear brake (center) hose fitting bolt (8)
to 21 N·m (15 lb ft).
2. Install the left rear pipe (1) and the right rear,
pipe (5) to the brake hose (3).
Tighten
• Tighten the left rear pipe (1) and the right rear
pipe
(5) at the rear brake (center) hose (3) to
24 N-m (18 lb ft).
• Tighten the left rear pipe
(1)
and the right rear
pipe (5) at the left hand brake hose to
15 N·m (11 lb ft).
3. Install the brake hose (3) into the brake hose
bracket (6). Ensure that the brake hose (3)
is
properly seated and not twisted.
4. Install the rear brake hose retainer (7) to the rear
brake .hose bracket (6) and the brake hose (3).
5. Install the rear brake front pipe (2) to the brake
hose (3).
• Use a backup wrench on the brake hose (3).
• Do not bend the brake hose bracket (6) or
the rear brake front pipe (2).
Tighten
Tighten the rear brake'front pipe
(2)
to the
rear brake (center) hose
(3)
to
15 N·m (11 lb ft).
6.
Bleed the brake hydraulic system. Refer to
Hydraulic Brake System Bleeding (Manual
Bleeding) or Hydraulic Brake System Bleeding
(Pressure Bleeding).
7. Lower the vehicle.
(