GMC chevrolet camaro 2000 Service Manual page 165

282941
365450
365450
Compressor Hose Assembly
Replacement (5.7 L)
Removal Procedure
HVAC
1 . Recover the refrigerant. Refer to Refrigerant
Recovery and Recharging.
2. Remove the air conditioning (A/C) compressor
and condenser hose from the clip on the fan
shroud.
3. Remove the A/C compressor and condenser hose
bolt at the accumulator.
4. Discard the 0-ring.
5. Raise and suitably support the vehicle. Refer to
Lifting and Jacking the Vehicle in General
Information.
6. Remove the A/C compressor and condenser hose
nut at the condenser.
7. Discard the 0-ring.
8. Remove the A/C compressor. Refer to
Compressor Replacement (5.7 L}.
9. Remove the A/C compressor and condenser hose
from the vehicle.
10. Discard the 0-ring.
Installation Procedure
Lightly coat the 0-rings with the mineral
base 525 viscosity refrigerant oil.
1. Install a new 0-ring to the A/C compressor and
condenser hose.
2. Install the compressor and condenser hose to the
vehicle.
3. Install the A/C compressor. Refer to Compressor
Replacement (5. 7 L).
4. Install a new 0-ring.
Notice: Refer to Fastener Notice in Cautions and
Notices.
5. Install the A/C compressor and condenser hose
nut at the condenser.
Tighten (
Tighten the A/C compressor and condenser hose
nut at the condenser to 16 N·m (12 lb ft).
6. Lower the vehicle.