GMC chevrolet camaro 2000 Service Manual page 262

Steering
3. A1tach J 43485 to J 35555 or equivalent.
) 4. Place J 43485 on or in the pump reservoir
)
filler neck.
5. Apply a vacuum of 68 kPa (20 in Hg) maximum.
6. Wait 5 minutes.
Typical vacuum drop is 7-10 kPa (2-3 in Hg). If
the vacuum does not remain steady, refer to
Excessive Vacuum Drop Diagnosis at the end of
this procedure.
7. Remove the J 43485 and the J 35555.
8. Reinstall the pump reservoir cap.
9. Start the engine. Allow the engine to idle.
10. Turn off the engine.
11. Verify the fluid level. Repeat steps 9 through 11
until fluid stabilizes.
Important: Do not turn steering wheel to lock.
12. Start the engine. Allow the engine to idle.
13. Turn the steering wheel 180-360 degrees in both
directions 5 times.
Power Steering System 2-15
J 35555
0
443646
443650
443653