Table of Contents
Advertisement
)
Suspension
Steering Knuckle Replacement
Removal Procedure
Tools
Required
• J
24319-01
Universal Steering Linkage Puller
• J
39549
Ball Joint/Tie Rod Separator
1. Raise and suitably support the vehicle. Refer to
Lifting and Jacking the Vehicle
in General
Information.
2. Remove the stabilizer shaft link. Refer to
Stabilizer
Shaft Link Replacement.
3. Remove the wheel hub (4) from the steering
knuckle (1 ). Refer to
Wheel Bearing/Hub
Replacement - Front.
4. Remove and discard the cotter pin (3) from the
outer tie rod end (1 ).
5. Remove the outer tie rod end nut (2).
6. Using J
24319-01
separate the outer tie rod
end (2) from the steering knuckle (1 ).
7. Use a jack stand to support the lower control arm.
8. Remove the shock absorber lower bolts and nuts.
9. Remove and discard the upper control arm
cotter pin.
10. Remove the upper control arm nut.
Front Suspension 3-25
181077
3
2
) /
~
I
423439
2
297353
Advertisement
Chapters
Table of Contents
