Stabilizer Shaft Replacement - GMC chevrolet camaro 2000 Service Manual

Suspension
Stabilizer Shaft Replacement
) Removal Procedure
\
J
1. Raise and suitably support the vehicle. Refer to
Lifting and Jacking the Vehicle in General
Information.
2. Remove the stabilizer shaft link. Refer to Stabilizer
Shaft Link Replacement.
3. Remove the stabilizer shaft insulator clamp
bolts (4) and stud.
4. Remove the stabilizer shaft insulator clamps (5).
5. Remove the stabilizer shaft (7) from the vehicle.
6. Remove the insulators (6) from the stabilizer
shaft (7), if necessary.
Installation Procedure
Important: The slit in the insulator (6) must face
toward the front of the vehicle.
1. Install the stabilizer shaft insulators (6) over the
stabilizer shaft (7), if necessary.
2. Place the stabilizer shaft (7) into position on the
vehicle.
3. Install the stabilizer shaft insulator clamps (5) over
the insulators.
Notice: Refer to Fastener Notice in Cautions and
Notices.
4. Install the stabilizer shaft insulator clamp bolts (4)
and stud.
Tighten
Tighten the stabilizer shaft ins.ulator clamp
bolts (4) and stud to 55 N-m (41 lb ft).
5. Install the stabilizer shaft link. Refer to Stabilizer
Shaft Link Replacement.
6. Lower the vehicle.
Front Suspension 3-19
4
181093
1 . . . · .
i~
1
; 1
I
lJ
2
3
5
181093