Table of Contents
Advertisement
)
)
Brakes
Brake Pressure Modulator Valve (BPMV)
Replacement
Removal Procedure
Caution: For safety reasons, the Brake Pressure
Modulator Valve (BPMV) must not be repaired, the
complete unit must be replaced. With the
4
exception of the EBCMIEBTCM, no screws may be
loosened. If screws are loosened, it will not be
possible to get the brake circuits leak-tight
and personal injury may result.
1. Turn the ignition switch to the OFF position.
2. Disconnect the EBCM harness connector (6).
Important: Note the locations of the brake pipes in
order to aid in installation.
3. Disconnect the brake pipes from the BPMV.
3
4. Remove the two nuts that connect the BPMV to
the BPMV bracket (3).
Notice:
When removing the brake pressure modulator
valve, protect the vehicle exterior from possible
brake fluid spillage. Brake fluid can cause damage to
painted surfaces.
5. Remove the BPMV and EBCM as an assembly
from the vehicle (5).
Antilock Brake System
5-237
213428
255229
Advertisement
Chapters
Table of Contents
