GMC chevrolet camaro 2000 Service Manual page 508

Brakes
2. Install the clutch master cylinder nuts (13), if
equipped with a manual transmission.
)
Notice: Refer to Fastener Notice in Cautions and
Notices.
)
3. Install the brake pedal nuts (3) and brake pedal
bracket bolts/screws (1 ).
Tighten
• Tighten the clutch master cylinder nuts (13) to
27
N·m
(20
lb ft), if equipped with a manual
transmission.
• Tighten the brake pedal bracket bolts (1) to
25 N-m (18 lb ft).
• Tighten the brake pedal nuts (3) to
20
N-m
(15
lb ft) in the following sequence:
3.1. Inboard upper
3.2. Outboard lower
3.3. Outboard upper
3.4. Inboard lower
4.
Install the accelerator pedal
(14).
5. Lubricate the clutch pedal pin (6) with chassis
lubricant.
6. Install the clutch pedal lever pin retainer (4) and
the clutch master cylinder pushrod
(5)
to the
clutch pedal pin (6), if equipped with a manual
transmission.
7. Lubricate the brake pedal pin (1 O) with chassis
lubricant.
8.
Install the following components to the brake
pedal pin:
• The brake pedal pushrod pin retainer
• The brake pedal pushrod
• The brake pedal pushrod washer
9. Install the following components to the pedal with
the bracket (16). Refer to Stop/amp Switch
Replacement.
• Cruise control release switch
• Stoplamp and TCC switch
• Cruise control clutch switch or cruise control
clutch anticipate switch
1 O.
Install the clutch start switch to the brake pedal
with the bracket, if equipped with a manual
transmission. ·
11. Adjust the following components. Refer to
Stop/amp Switch Adjustment.
" Cruise control release switch
• Stoplamp and TCC switch
• Cruise control clutch switch or cruise control
clutch anticipate switch
12. Install the left side instrument panel insulator.
Refer to Closeout/Insulator Panel Replacement
- Left in Instrument Panel, Gauges and Console.
) 13. Connect the negative battery cable.
Tighten
Tighten the negative battery cable to
15 N-m (11 lb ft).
Hydraulic Brakes 5-35
182817