Brake Hose Inspection - GMC chevrolet camaro 2000 Service Manual

5-38 Hydraulic Brakes
219471
Brakes
20. Use a tube bender in order to bend the new pipe
to match the old pipe.
21. Maintain the following clearances: (
• Maintain the minimum clearance of
19 mm (0.75 in) to all moving components.
• Maintain the minimum clearance of
13 mm (0.50 in) to all vibrating components.
• Maintain the minimum clearance of
7 mm (0.25 in) to any shielded lines, unless
clipped to a component.
Brake Hose Inspection
Inspect the brake hoses and the brake pipes at least
two times a year for the following problems:
• Check the outer cover for road damage.
• Check for fluid leaks.
• Check for damage at the brake hose and pipe
connections.
• Check that all hose and pipe mounting hardware (
is securely in place. Repair the mounting
hardware as needed.
• Make sure all mounting hardware is in place and
secure.
• Replace or repair any parts as necessary.
Power Brake Booster Hoses, Pipes And
Fittings
Check all pipes, hoses and fittings for leaks at regular
intervals. Make sure the fittings are tight. Make
sure all clamps, clips and unions supporting the pipes
and hoses are in place and properly secured. Make
sure all hoses are installed in a matter that does
not cause chafing or wear on the hoses. Check for
leaks by wiping the suspected area clean. Spotting
leaking fluid is easier when the suspected area
in clean. When fluid leaks appear, tighten, repair or
replace nearby fittings and bolts.