GMC chevrolet camaro 2000 Service Manual page 711

5-238 Antilock Brake System
255229
4
3
213428
Brakes
Installation Procedure
Important: If a new BPMV is being installed, remove (
the shipping plugs from the valve openings in the
compartment during the next step.
Important: Use the locations noted during remo\lal.
1.
Install BPMV and EBCM as an assembly into the
BPMV bracket.(2).
2. Install the two BPMV bracket nuts (3).
Tighten
Tighten the two BPMV to BPMV bracket nuts to
12 N-m (8 lb ft.)
Caution: Make sure brake pipes are correctly
connected to brake pressure modulator valve. If
brake pipes are switched by mistake, wheel lockup
will occur and personal injury may result. The
only two ways this condition can be detected are
by using a Scan Tool or by doing an Antilock stop.
3. Install the brake pipes on to the BPMV.
Tighten
Tighten the brake pipe fittings to 15 N-m (11 lb ft).
4. Connect the EBCM harness connector (6).
5. Turn the ignition switch to the RUN position,
engine off.
6. Perform the A Diagnostic System Check - ABS
(