GMC chevrolet camaro 2000 Service Manual page 492

Brakes
Hydraulic Brakes 5-19
Brake Warning Indicator Inoperative (cont'd)
Step Action
Value(s)
Yes No
Test and repair a poor connection at the park brake switch
13
grbund. Refer.to Testing for Intermittent and Poor
'Connections and Connector Repairs .in Wiring Systems.
-
Did you find and repair a poor connection.?
Go to Step 23
Go to Step 14
14
Replace the park brake switch.
Did you complete the replacement?
-
-
Go to Step23
Determine if this vehicle is either otthe following types:
15
• Domestic
• Gulf States
-
Is the veh.icle one of the above types?
Go to Step 16
Go to Step 19
1. Leave the 1 OA fused jumper connected between the
park brake switch connector and ground.
2. Disconnect the daytime running lights (DRL) module
connector C2.
I
16
3. Connect a.fused jumper between the DRL module
-
connector C2 terminal D and terminal E. Refer to
Circuit Testing in Wiring Systems.
4. Turn the ignition switch to the RUN position.
Is the brake warning indicator on? Go to Step 21 Go to Step 17
1. Connect a 1 OA fused jumpeUrom the DRL module
connector C2 terminal D to the ground. Refer to
17
Circuit Testing in Wiring Systems'.
-
2. Turn the ignition switch to the HUN position.
) 3; rs the brake warning·indicatoron?
Go to Step 18 Go to Step 19
Repair the open in circuit 1134 between ihe DRL module
18
connector C2 terminal E and the park brake switch. Refer
to Wiring Repairs in Wiring Systems.
-
-
Did you complete the repair? Go to Step 23
Test for and repair a poor co.nnection at the instrument
cluster connector terminal A5. Refer to Testing for
19
Intermittent and Poor Connections and Connector Repairs
-
in Wiring Systems.
Did you find and repair a poor connection? Go to Step 23 Go to Step 20
Repair the open in circuit 33 between the instrument
cluster connector terminal A5 and the DRL module
20 . · connector C2 terminal D (Domestic or Gulf States) or the
park brake switch .(Europe
or
Japan). Refer to Wiring
-
-
Repairs in Wiring Systems.
Did you complete the repair? Go to Step 23
Test for and repair a poor connection at the DRL module
connector C2 terminal D and terminal. E. Refer to Testing
21
for Intermittent and Poor Connections and Connector
-
Repairs in Wiring Systems.
Did you find and repair a poor conn.ection? Go to Step 23 Go to Step 22
Replace the DRL module. Refer to Daytime Running
22
Lights (ORL) Control Module Replacement in Lighting.
- -
Did you. complete .the replacement? Go to Step 23
23
Operate the system in orderto verify the repair.
-
Did you correct the condition? System OK Go to Step 3
)