Clutch Rotor And/Or Bearing Removal; Clutch Rotor And/Or Bearing Removal (V7 Direct Mount) - GMC chevrolet camaro 2000 Service Manual

1.:3g Heating, Ventilation and Air Conditioning HVAC
237121
J
9398-A
J 33020
210141
157595
4. Install the J 33020 into the inner circle of. slo1s in
the rotor.
5. Turn the J33020 clockwise in the slots in order to
engage the tangs of the puller with the segments
between the slots in the rotor.
6. Hold the J 33020 in place. Tighten the puller
screw against the puller guide in order to
remove the puller rotor and bearing assembly.
7. Support the rotor hub in order to prevent damage
to the pulley rotor during bearing removal.
7.1. Remove the forcing screw from the
J 33020.
7.2. With the tangs of the J 33020 still engaged
in the rotor slots, invert the assembly onto a
solid, flat surface or blocks.
Notice: It is not necessary to remove the staking in
front of the bearing to remove the bearing, however, it
will be necessary to file away the old stake metal
for proper clearance for the new bearing to be installed
into the rotor bore or the bearing may be damaged.
8. Use a J 9398 with the J 8092 in order to drive the
bearing out of the rotor hub.
Clutch Rotor and/or Bearing Removal
(V7
D
Direct Mount)
Tools Required
" J 33023-A Puller Pilot
• J
41552 Compressor Pulley Puller
O
J 41790 Compressor Holding Fixture
1. Remove the compressor from the vehicle.
2. Clamp the compressor holding fixture, J 41790 in
a vise and attach the compressor to the J 41790.
(
(