Steering Column Housing - Assemble - GMC chervolet camaro 1999 Service Manual

Steering
Steering Column Housing - Assemble
Assembly Procedure
Tools Required
• J 38639 Steering Column Housing
Bearing Installer
• J 8092 Driver Handle
• J 22635 Lock Shoe and Release Lever Pin
Remover and Installer
1. To assemble the steering column housing
assembly if needed:
2. Install the bearing assembly (1)
3. Install the shoe springs (5).
4. Install the steering wheel lock shoes (10) and (11).
5. Install the dowel pin (7).
6. Install the releasf\l fever spring (4).
7. Install the shoe rel1:3ase lever (2).
8. Install the release lever pin {3) using J 22635.
9. Install the drive shaft (8).
10. Install the switch actuator sector (13).
11. Install the rack preload spring (16).
12. Install the switch actuator rack (17) to the switch
actuator sector (13).
13. Install the bearing assembly (12) using
J 8092 and J 38639. ·
14. Install the wire protector shield (9).
Important: If the steering column housing assembly
has been staked (2) 3 times by the pivot pins (1) it
must be replaced.
15. Install the steering column housing assembly.
Steering Wheel and Column - Tilt 2:-97
354085
354605