Turn Signal And Multifunction Switch; Assembly - Disassemble - Off Vehicle - GMC chevrolet camaro 2000 Service Manual

2-72 Steering Wheel and Column - Tilt
343711
354112
354116
Steering
8. Install the small wire harness straps.
9. Install the wire harness assembly strap (1 ). (
10. Remove the steering column and J 41352 from
the vise.
Turn Signal and Multifunction Switch
Assembly - Disassemble - Off Vehicle
Disassembly Procedure
1. Remove the tilt lever.
2. Remove the multifunction lever.
3. Remove the hazard knob.
4. Remove the turn signal cancel cam assembly.
Refer to Turn Signal Cancel Cam and Upper
Bearing Inner Race - Disassemble - Off Vehicle.
5. Remove the round washer head screw (2) from
the signal switch arm assembly (3).
6.
Pry out the signal switch arm assembly (3) from
the lock housing cover and sleeve assembly.
7. Remove the 3 pan head 6 lobed socket screws (1)
from the turn signal switch assembly.
8. In order to remove the turn signal switch
assembly, use the following steps:
8.1. Remove the steering column wire
harness strap.
8.2. Remove the wiring protector.
(