Windshield Wiper And Washer Switch; Assembly - Disassemble - Off Vehicle; Windshield Wiper And Washer Switch Assembly - Assemble - Off Vehicle - GMC chevrolet camaro 2000 Service Manual

\
)
Steering
Windshield Wiper and Washer Switch
Assembly - Disassemble - Off Vehicle
Disassembly Procedure
1 . Remove the lock housing cover and sleeve
assembly. Refer to Lock Housing Assembly -
Disassemble - Off Vehicle.
2. Remove the switch actuator pivot pin (2) from the
pivot and pulse switch assembly (1 ).
3. If removal of the pivot and pulse switch
assembly (1) is not needed let. the pivot and pulse
switch assembly (1) hang freely.
4. Remove the pivot and pulse switch assembly (1)
from the lock housing cover and sleeve assembly
following these steps:
4.1. Remove the wire protector shield.
4.2. Remove the pivot and pulse switch
assembly connector from the bulk head
connector.
Important: Use care not to damage the wires when
pulling the pivot and pulse switch assembly wire
harness through the steering column.
4.3. Pull the wire harness through the steering
column.
Windshield Wiper and Washer·Switch
Assembly - Assemble - Off Vehicle
Assembly Procedure
1. Install the pivot and pulse switch assembly to the
lock housing cover and sleeve assembly.
2. Lubricate the switch actuator pivot pin (2) with
lithium grease.
3. Install the switch actuator pivot pin (2) into the
pivot and pulse switch assembly (1) and the
lock housing cover and sleeve assembly.
Important: Use care not to damage the wires when
pulling the pivot and pulse switch assembly wire
harness through the steering column.
4. Pull the pivot and pulse switch assembly wire
harness through the steering column.
5. Install the pivot and pulse switch assembly
connector to the bulkhead connector.
6. Install the wire protector shield.
7. Install the lock housing cover and sleeve
assembly. Refer to. Lock Housing Assembly
- Assemble - Off Vehicle. ·
Steering Wheel and Column - Tilt 2-77
343835
343861