Steering
Installation Procedure
1. Connect the reservoir and outlet hoses (4, 6) to
the reservoir (1 ).
2. Install the reservoir (1) to the bracket (2).
3. Refill the reservoir and Install the cap to the
reservoir.
4. Remove drain pan.
5. Bleed the power steering system. Refer to
Bleeding Power Steering System.
Remote PS Fluid Reservoir Bracket
Replacement
Removal Procedure
1. Remove the reservoir (1) from the bracket (2).
2. Use a wire, or an equivalent, in order to secure the
reservoir (1) in an upright position.
An upright position will prevent leakage.
3. Raise and support the vehicle. Refer to Lifting and
Jacking the Vehicle in General Information.
4. Remove the electrical harness from the
bracket (2).
5. Remove the bolt/screw (1 ).
6. Remove the nuts (2).
Power Steering System 2-19
290572
290572
290571