GMC chevrolet camaro 2000 Service Manual page 287

2-40 Power Steering System
2
297628
423439
Steering
2. Connect the outer tie rod assembly (2) to the
steering knuckle (1 ).
3. Connect the hex slotted nut (2) to the outer tie rod
stud (1 ).
Notice:
Refer to
Fastener Notice
in Cautions and
Notices.
Tighten
Tighten the hex slotted nut (2) to 47 N-m (35 lb
ft).
Align the cotter pin slot by tightening the hex
slotted nut
(2)
up to
1/6
additional turn, or (
70 N-m (52 lb ft) maximum. Do not back off the
hex slotted nut (2) for the cotter pin (3) insertion.
4. Install the cotter pin (3) into the hole in the
tie rod stud.
Important:
Be sure the rack and pinion boot is not
twisted or puckered during toe adjustment.
5. Adjust the toe by turning the inner tie rod. Follow
recommended manufacturer specifications.
Tighten
Tighten the hex jam nut against the outer tie rod
to 68 N·m (50 lb
ft).
(