Clutch Rotor And/Or Bearing Install (V7 - Direct Mount) - GMC chevrolet camaro 2000 Service Manual

1.;.52 Heating, Ventilation and Air Conditioning HVAC
J 8433-1 J 8433-3
J
34992
J 33013-B
J 33017
237122
iO. With the compressor mounted to the J 34992,
position the rotor and bearing assembly on the
front head.
11. Position the J 33017 and the J 33023-A directly
over
the inner race of the bearing.
12.
Position the
J
8433-1 on the
J
33023-A.
13. Assemble the two through bolts and the washers
of the
J
349Q2 through the slots of the
J
8433-1 ..
14. Thread the tvvo through bolts into the·
J
34992.
Ensure that the thread of the through bolts
engages the full thickness of the J 34992.
15.
Tighten the
J
8433-3 in the
J
8433-1 in order to
force the pulley rotor and bearing assembly onto
the front head of the compressor.
16.
If the
J
33017 slips off direct, in-line contact With
inner face of the bearing, use the following steps:
16.1. Loosen the J 8433-3.
16.2.
Realign the
J
33017 and the
J
.33023-A in
order to ensure that the in$taller clears the
front head.
17.
Install the rotor and bearing assembly retainer
ring using the
J
6083. ·
) 18. Install the clutch plate and hub assembly. Refer to
/ Compressor Clutch Plate/Hub Assembly Install
237119
157226
(VS - Conventional Mount). ·
Clutch Rotor and/or Bearing Install
(V7 - Direct Mount)
Tools Required
" J
33013-B Hub and Drive Plate Remover/Installer
" J 33017 Pulley and Bearing Assembly Installer
1. Position the clutch rotor and bearing assembly (2)
onto the compressor.
2. Position the
J
33017 and bearing (1) from the
J 33013-B directly
over
the inner race of the
bearing.
3. Place the washer (3) from the
J
42126 tool kit
onto the body of the
J
33013-B.
4.
Remove the center screw from the body of
the J 33013-8.
5.
Install the center screw into the opposite end
of
the
J
33013-8.
(
(
(