Turn Signal Cancel Cam And Upper; Bearing Inner Race - Disassemble; Off Vehicle - GMC chevrolet camaro 2000 Service Manual

2-82 Steering Wheel, c:1nd Column - Tilt
569765
343728
344003
Steering
9. Rotate the tool bolt clockwise with a wrench until
it contacts the surface of the tool block.
10. Make a one fourth turn counter clockwise to the
hexagon section on the end of the tool bolt.
11. Unscrew the tool bolt until the wheel tilt spring
and the spring retainer (1) ,are free.
12. Remove J 39246.
13. Install the lock housing cover and sleeve
assembly. Refer to Lock Housing Assembly
- Assemble - Off Vehicle.
Turn Signal Cancel Cam ,and Upper
Bearing Inner Race - Disassemble -
Off Vehicle ,
Disassembly Procedure
Tools Required
J 23653-SIR Lock Plate Compressor
1. Remove the SIR coil assembly. Refer to Inflatable
Restraint Steering Wheel Module Coil -
Disassemble - Off Vehicle.
2. Remove the wave washer.
3. Compress the shaft lock using J 23653-SIR.
4. Remove the bearing retainer (1) from the steering
shaft assembly and dispose of it.
5. Remove J 23653-SIR.
6. Remove the following 3 parts from the steering
shaft assembly:
6.1. Remove the shaft lock shield assembly (1 ).
6.2. Remove the turn signal cancel cam
assembly (2).
6.3. Remove the upper bearing spring (3).
(
(