Power Steering Pump - GMC chevrolet camaro 2000 Service Manual

Steering
Installation Procedure
) Tools Required
J 25033-C Power Steering Pump Pulley Installer
important:
" 3.8 Liter Engine: Ensure that the face of the pulley
hub is flush with the end of the pump shaft before
you apply a load to the pulley hub.
• 5.7 Liter Engine: Ensure that the pulley hub
shoulder bottoms out completely on the pulley
shaft before you apply a load to the pulley hub.
• Ensure that the pulley goes on snug when
installing the pulley with the special tool. If the
pulley installs onto the pump shaft too easily, it will
not relay engine power to the pump and should
be replaced.
1 . Use the· J 25033-C in order to· install the power
steering pulley to the power steering pump.
2. Install the air intake resonator and mass airflow
assembly (LS1 only)
3. Install the serpentine belt.
4. Check power steering operation and visibly check
pulley for any irregular wobble when operating.
Power Steering Pump Replace.ment (V8)
Removal Procedure
1. Place a drain pan under the power steering
pump (1).
2. Remove the air intake resonator and mass airflow
assembly.
3. Remove the serpentine belt.
4. Remove the power steering pump pulley: Refer to
Power Steering Pulley Replacement.
5. Remove the outlet hose and the clamp from the
reservoir (This allows fluid to drain from reservoir).
6. Remove the inlet hose fitting from the pump.
7. Remove power steering pump attaching bolts (4)
and power steering pump front brace (3) from
pump (1).
8. Remove pump (1) from rear bracket (2).
Power Steering System 2.;.21
2
290557
290570