Brakes
7. Clamp the J 29803-Ain a vise.
8. Select the correct size collet (2) and forming
mandrel for the pipe size used.
9. Insert the properly formed mandrel (3) into the
J 29803-A.
10. Hold the forming mandrel (3) i.n place using
your finger.
11. Thread in the forcing screw (2) until contact is
made and the screw begins to move the forming
mandrel (3).
12. Turn .the forcing screw back one complete turn.
13. Slide the clamping nut over the brake pipe.
14. Insert the prepared brake pipe into the.correct
collet (2). · .
Leave approximately
19
mm (0. 750 in) of tubing
extending out of the collet.
Insert the assembly into the J 29803-A.
Ensure that the brake pipe end contacts the face
of the forming mandrel.
15. Tighten the clamping nut (1) into the J 29803-A
body tightly in order to ensure that the pipe will
not push out.
16. Wrench tighten the forcing screw until the screw
bottoms. Do not over tighten the forcing screw or
the flare may become oversized.
)
17. Back the clamping nut (1) out of the J 29803-A.
18. Disassemble the clamping nut (1) and the
collet assembly.
19. The flare is now ready for use.
Hydraulic Brakes 5-37
J 29803-A
63931
J 29803-A
63927
J 29803-A
63931