Pinion Oil Seal Replacement - GMC chevrolet camaro 2000 Service Manual

4--38 Rear Drive Axle
\
;/
J 8614-01
J 8614-2
164053
2
164050
164041
Pinion Oil Seal Replacement
Removal Procedure
Tools Required
DrivelineJAxle
J 8614-01 Pinion Flange Remover and Installer
1. Raise and suitably support the vehicle. Refer to
Lifting and Jacking the. Vehicle in General
Information.
2. Remove the propeller shaft. Refer to Propeller
Shaft Replacement - One Piece
or
Propeller
Shaft Replacement - Two Piece in Propeller Shaft.
3. Mark the position of the following components
before disassembly:
• The drive pinion gear yoke (1)
• The drive pinion gear
• The drive pinion gear nut
This action will ensure that.the correct drive
pinion gear inner and outer bearing preload
can be maintained.
4. Use J 8614,0,1 in order to remove the following
components:
. • The. drive pinion ~e_ar nut
• The drive pinion gear washer
5. Use
a
suitable container in order to hold any fluid
that may drain from the rear axle.
6. Use J 8614-01 in order to remove the drive pinion
gear yoke (1). · '
(
(