GMC chevrolet camaro 2000 Service Manual page 427

4~1o
Propeller Shaft
180335
2
1
180340
180337
Driveline/Axle
Installation Procedure
Notice: The propeller shaft must be supported
(
carefully during handling to avoid jamming or bending
of parts.
Important:
Do not place any tool between the
propeller shaft slip yoke and the splines. Placing any
tool between the propeller shaft slip yoke and the
splines may cause damage to the transmission
oil seal.
1 . Lubricate the slip yoke wit.h chassis lubricant.
2.
Install the slip yoke onto the transmission
output shaft.
Important:
Be sure to align the mark on the pinion
gear yoke with the mark on the propeller shaft.
3. Install the rear of the propeller shaft (2) to the
pinion gear yoke (1 ).
4. Install the rear universal joint to the pinion
gear yoke.
Ensure that the bearing caps are properly seated.
5. Install the propeller shaft retainers (1).
Notice: Refer to Fastener Notice in Cautions and
Notices.
6. Install the propeller shaft bolts/screws (2).
Tighten
Tighten the propeller shaft bolts/screws evenly to
22 N-m (16 lb ft). .
7.
Lower tAe vehicle ..
Propeller Shaft Replacement
~
Two Piece
Removal Procedure
Notice: Do not strike or drop the propeller shaft, or
allow the universal joints to bend to extreme angles, as
internal joint damage might occur.
Important:
The two-piece propeller shaft and the
center support bearing used with the 3800 (VIN K)
engine are not serviceable separately. The propeller
shaft and the support bearing should be replaced as a
complete assembly only.
1. Raise and suitably support the vehicle. Refer to
Lifting and Jacking the Vehicle in General
Information.
2. Mark the relationship of the propeller shaft (2) to
the pinion gear yoke (1 ).
(