GMC chevrolet camaro 2000 Service Manual page 614

Brakes
Antilock Brake System 5-141
DTC C0041 RF Wheel Speed Circuit Range/Performance (cont'd)
)
Step
Action
Value(s) Yes
No
Using J 39200 DMM, measure the resistance between
terminals 4 and 15 of J 39700 if the vehicle is equipped
with Traction Control. If the vehicle is not equipped with
11
traction control measure the resistance between
OL (infinite)
terminals 3 and 15 of J 39700.
Is the resistance within the range specified in the values
column? Go to Step 13 Go to Step 12
Repair CKT 872 for a short to ground. Refer: to Wiring
Repairs. If a short to ground is found in the jumper
12
harness, replace the jumper harness. Refer to
-
-
Wheel Speed Sensor Jumper Harness Replacement
(Front Right).
Is the repair complete? Go to Step 16
Using J 39200 DMM, measure the resistance between
13
terminals 5 and 15 of J 39700.
OL (infinite)
Is the resistance within the range specified in the values
column?
Go to Step 15 Go to Step 14
Repair CKT 833 for a short to ground. Refer to Wiring
Repairs. If a short to ground is found in the jumper
14
harness, replace the jumper harness. Refer to
-
Wheel Speed Sensor Jumper Harness Replacement
-
(Front Right).
Is the repair complete?
G.o to Step 16
Replace the EBCM. Refer to Electronic Brake Control
Go to A
15
Module (EBCM) Replacement.
-
Diagnostic
-
Is the replacement complete?
System
Check-ABS
1. Reconnect all previously disconnected components.
)
2. Using a scan tool clear the DTC.
16
3. Remove the scan tool from the DLC.
Goto A
-
4. Carefully drive vehicle above 12 Km/h (8 mph) for
Diagnostic
several minutes.
..
System
Does the OTC reset as a current OTC? Go to Step2 Check-ABS
)