Clutch Rotor And/Or Bearing Install (V5 - Conventional Mount) - GMC chevrolet camaro 2000 Service Manual

1.;50 Heating, Ventilation and Air Conditioning
HVAC
187363
157218
J8092
210146
8. Place a feeler gage between the clutch plate and
the clutch rotor.
Important: Make sure that the air gap is even all
around the clutch plate and hub assembly.
9. Tighten the hex portion of the J 33013-8 until the
air gap between the clutch plate and clutch rotor
is 0.40 mm (0.015 in).
10. Remove the J 33013-8.
11. Hold the clutch plate and hub assembly (2) .with
the J 33027-A.
12. Install the compressor shaft nut.
Tighten
· Tighten the compressor shaft nut to
17.5N·m (13 lb ft).
(
13. Spin the pulley rotor by hand to make sure the (
rotor is not rubbing against the clutch drive plate.
14. Remove the compressor from the J 41790.
15. Install the compressor into the vehicle.
Clutch Rotor and/or Bearing Install
(V5 - Conventional Mount)
Tools Required
• J 6083 Snap Ring Pliers
• J 8092 Driver Handle ·
• J 8433-1 Puller Bar
• J 8433-3 Forcing Screw
• J 9481-A Bearing Installer
• J 21352-A Support Block
• J 33017 Pulley And Bearing Assembly Installer
• J 33019 Bearing Staking Tool
• J 33023-A Puller Pilot
• J 34992 Compressor Holding Fixture
(