GMC chevrolet camaro 2000 Service Manual page 166

)
HVAC
Heating, Ventilation and Air Conditioning 1-69
7. Install a new 0-ring.
8. Install the A/C compressor and condenser hose
bolt at the accumulator.
Tighten
Tighten the A/C compressor and condenser hose
bolt at the accumulator to 16 N-m (12 lb ft).
9. Install the A/C compressor and condenser hose to
the clip on the fan shroud.
1 O. Recharge the A/C system. Refer to Refrigerant
Recovery and Recharging.
11. Perform a leak test on the A/C system. Refer to
Leak Testing. ·
Evaporator Tube Replacement
Removal Procedure
1. Recover the refrigerant. Refer to Refrigerant
Recovery and Recharging.
2. Disconnect the electrical connector at the air
conditioning (A/C) refrigerant pressure sensor.
3. Remove the A/C evaporator tube bolt at the
module.
4. Remove the A/C evaporator tube bolt at the
condenser.
5. Remove the A/C evaporator tube from the vehicle.
6. Discard the 0-rings.
7. Remove the orifice and the pressure sensor, if
replacing the tube.
282941
282947
282946