2-58
Steering Wheel and Column - Tilt
Steering
Tum Signal Switch Difficult to Operate
Problem
Action
The turn signal is difficult to operate.
1. Inspect for the following conditions:
• A loose turn signal switch arm
• Loose springs
• Misplaced springs
• Foreign parts or material
• Loose turn signal switch mounting screws
2.
Replace the switch if the following conditions exist:
O
A broken yoke
O
A distorted yoke
Hazard Switch Cannot Be Turned. Off
Problem
•.
Action
The hazard switch cannot be
1. Inspect for foreign material between the hazard support canceling leg and
turned off.
the yoke.
2. Replace the turn signal switch if no foreign material is found.
Hazard Switch Does Not Stay On
Problem
Action
The hazard switch will not stay on or
1. Inspect the steering column for the following conditions:
is difficult to turn off.
• A loose turn signal switch
• Interference with other components
• Interference from foreign material
2.
Replace the turn signal switch if none of the above conditions are found.
(
Ignition Switch Electrical System Does Not Operate
Problem
Action
The electrical system does not
Inspect the steering column for the following conditions:
function properly.
• A damaged ignition switch
• An improperly adjusted ignition switch
• A loose connector at the ignition switch
Ignition Switch Does Not Tum
Problem
Action
The ignition switch does not turn.
Inspect the steering column for the following conditions:
• A damaged ignition switch
• An improperly adjusted ignition switch
• A loose connector at the ignition switch·
Ignition Switch Cannot Be Set Correctly
Problem
Action
The ignition switch cannot be
Inspect the steering column for the following conditions:
correctly set.
O
A deformed switch actuator rod
• A sector to rack engaged in the wrong tooth
(