GMC chevrolet camaro 2000 Service Manual page 269

2.;.22 Power Steering System
290570
1 3
354420
Steering
Installation Procedure
Notice: Refer to Fastener Notice in Cautions and (
Notices.
1. Install pump (1 ), pump front brace (3), and
attaching bolts (4) to rear bracket (2).
Tighten
Tighten the bolts/screws to 25 N-m (18 lb ft).
2. Install the inlet hose fitting from pump.
Tighten
Tighten the fitting to 28 N-m (21 lb ft).
3.
Install the outlet hose and clamp to reservoir.
4. Install the power steering pump pulley. Refer to
Power Steering Pulley Replacement.
5. Install the serpentine belt.
6.
Install the air intake resonator and mass airflow
assembly.
7.
Remove. drain pan.
8. Refill and bleed the power steering system. Refer
to Bleeding Power Steering System.
Power Steering Pump Replacement (V6)
Removal Procedure
1. Place a drain pan under the power steering
pump (1).
2. Remove the serpentine belt.
3. Remove the front air intake duct.
4. Remove the pulley from the power steering
pump (1 ). Refer to Remote Power Steering
Fluid Reservoir Replacement.
5. Disconnect the inlet hose (3) from the power
steering pump (1 ).
6. Disconnect the reservoir hose (2) from the power
steering pump (1 ).
(