Wheel Bearing/Hub Replacement - Front - GMC chevrolet camaro 2000 Service Manual

3-24 Front Suspension
Suspension
7. Install the tire and wheel. Refer to Tire and Wheel
Removal and Installation in Tires and Wheels.
8.
Lower the vehicle.
9. Check the wheel alignment. Refer to Measuring
Wheel Alignment in Wheel Alignment.
Wheel Bearing/Hub Replacement - Front
Removal Procedure
1.
Raise and suitably support the vehicle. Refer to
Lifting and Jacking the Vehicle in. General
Information.
2. Remove the tire and wheel. Refer to Tire and
Wheel Removal and Installation in Tires and
Wheels.
3. Remove the brake caliper (3) from its mounting.
4. Support the brake caliper (3) on the steering
knuckle using mechanics wire.
5. Remove the brake rotor (5) from the wheel
bearing hub (4).
6.
Disconnect the wheel speed sensor .electrical
connector.
7.
Remove the wheel bearing hub bolts
(6
and 7)
and. wheel speed sensor wire bracket (8).
181on
8. Pull the wheel bearing hub (4) from the steering
181077
knuckle
(1 ).
Installation Procedure
1. Align the wheel bearing hub (4) to tlie steering
knuckle
(1 ).
Notice: Refer to Fastener Notice in Cautions .and
Notices.
2.
Install the wheel bearing hub bolts
(6
and
7)
and
wheel speed sensor wire bracket (8).
Tighten
Tighten the wheel bearing hub bolts (6 and 7) to
86 N·m (63 lb ft).
3. Connect the wheel speed sensor electrical
connector. Attach the wheel speed sensor wire to
the bracket (8). ·
4. Install the brake rotor (5) to the wheel bearing
hub (4).
5. Remove the brake caliper (3) from the mechanics
yvire support.
6. Install the brake caliper (3) to its mounting.
7. Install the tire and the wheel. Refer to Tire and
Wheel Removal and Installation in Tires and
Wheels.
8. Lower the vehicle.
(
(