Master Cylinder Fluid Level Sensor; Replacement - GMC chevrolet camaro 2000 Service Manual

5-26 Hydraulic Brakes
385563
400336
Brakes
8. Stroke the primary piston several times.
9. Reposition the brake master cylinder in the vise.
Level the master cylinder. (
10. Loosen the fabricated plugs one at a time.
11.
Push the primary piston into the rnaster cylinder
bore in order to force the air out of the master
cylinder.
Important: In order to prevent air from sucking back
into the master cylinder, tighten the fabricated
plugs before allowing the primary piston to return to its
original position. ·
12. Repeat the previous 6 steps until no air escapes
past the plugs.
13. Install the master cylinder into .the vehicle. Refer
to Masterc;ytinder Replacement.
Master Cylinder Fluid
Level
Sensor
Replacement
Removal Procedure
1.
Disconnect low brake fluid sensor electrical
connector (2) from the sensor (1).
Important: If the sensor is being replaced, remove
and replace the sensor float that resides within 1he
master cylinder reservoir. ·
2. Using needlenose pliers, remove the sensor (2)
from the reservoir
(1)
by squeezing the outer
tangs together and removing th.e sens.or by hand.
(