GMC chevrolet camaro 2000 Service Manual page 316

Steering
Installation Procedure
) Notice:
If a service replacement steering column is
being installed, do not remove the antirotation pin until
after the column has been connected to the steering
gear. Removing the antirotation pin before the column
is connected to the steering gear may damage the
SIR coil.
)
1. Position the column (3) into the vehicle.
2.
Install the automatic transmission park lock cable
to 1he ignition switch, if equipped. Refer to
Au1omatic Transmission, On-Vehicle Service.
Notice:
Refer to Fastener Notice in Cautions and
Notices.
3. Install the shims (6) and the nuts (5) to the
steering column support.
Tighten
Tighten the steering column support nuts to
25 N-m (18 lb ft).
4. Install the intermediate steering shaft bolt to the
steering gear coupling shaft. Refer to Steering
Gear Coupling Shaft.
5. Install the cover to the dash. Install the bolt in the
following order:
5.1. Install the lower (3) bolt.
5.2. Install the outboard (4) bolt.
5.3. Install the inboard (2) bolt.
6. Position the cover to the dash panel.
7. Connect the electrical connectors.
8. Install the dash panel bolts.
Tighten
Tighten the dash panel bolts to 18 N,m (14 lb ft).
9. Install the steering wheel, if column is replaced.
Refer to Steering Wheel Replacement.
10.
Enable the SIR system.
11.
Install the instrument panel driver knee. bolster
and deflector.
12.
Install the left instrument panel insulator.
Steering Wheel and Column - Tilt 2-69
290448
290294