Table of Contents
Advertisement
Steering
4. Lower vehicle.
5.
Remove the serpentine belt.
6.
Remove the power steering pump pulley. Refer to
Power Steering Pulley Replacement.
7. Remove inlet hose fitting (3) from pump (1).
8.
Remove outlet hose from reservoir.
Installation Procedure
Important:
Inlet and outlet hoses must be oriented so
as adequate clearance is maintained between both
hoses and surrounding components to prevent chafing.
Use minimum clearance of
12
mm (0.47 in). The
outlet hose must not be twisted during installation. Do
not bend or distort inlet and outlet hoses to make
installation easier. Failure to follow these procedures
could result in component damage.
1.
Install outlet hose to reservoir.
2. Install inlet hose fitting (3) to pump (1).
3.
Install the power steering pump pulley. Refer to
Power Steering Pulley Replacement.
4.
Install the serpentine belt.
5.
Raise and suitably support vehicle. Refer t.o Lifting
and Jacking the Vehicle in General Information.
Notice:
Refer to Fas.tener Notice in Cautions and
Notices.
·
6.
Install inlet and outlet hoses
(2, 3)
to steering
gear (1 ).
Tighten
..
• Tighten the inlet hose (3) to 28 N·m (21 lb ft).
• Tighten the outlet hose (2) to 28 N·m (21 lb ft).
7. Lower vehicle.
8. Remove drain pan.
9. Refill and bleed power steering system: Refer to
Bleeding Power Steering System.
Power Steering System 2~33
1
3
354420
1
3
354420
1
3
2
354423
Advertisement
Chapters
Table of Contents
