GMC chevrolet camaro 2000 Service Manual page 131

282955
365446
Installation Procedure
Important: NEW A/C compressors are shipped
WITHOUT poly-alkylene glycol (PAG) oil.
HVAC
1.
If a NEW A/C compressor is being installed, add
60 ml (2 oz) of PAG oil to the compressor.
2. If reinstalling the old A/C compressor perform the
following:
2.1.
Drain, measure and record the amount of
PAG oil in the A/C compressor.
2.2. If the measured amount of PAG oil drained
is less than or equal to 60 ml (2 oz), add
60 ml (2 oz) of new, clean PAG oil to
the A/C compressor.
2.3. If the measured amount of PAG oil drained
is greater than 60 ml (2 oz), add the same
amount of new, clean PAG oil to the
A/C compressor.
Notice:
Refer to
Fastener Notice
in Cautions and
Notices.
2.4. Install the compr13ssor crankcase oil. drain
bolt (1) to the replacement compressor:
Tighten
Tighten the compressor crankcase oil drain
bolt (1) to 20 N-m (15 lb ft).
3. Install the A/C compressor.
4. Install the A/C compressor bolts.
Tighten
Tighten the A/C compressor bolts to
50 N·m (37 lb ft).
5. Connect the electrical connector to the
A/C compressor.
(
(