GMC chevrolet camaro 2000 Service Manual page 534

)
)
Brakes
7. Remove the rear brake caliper from the mounting
plate. Refer to Brake Caliper Replacement (Rear).
Ensure that weight of caliper is adequately
supported.
8. Remove the inner and outer brake pads (2) from
the mounting plate (1 ).
9. Clean all the residue from the shoe guide surfaces
on the caliper mounting plate and the rear brake
caliper.
10. Inspect the caliper guide pins for free movement
in the caliper mounting plate.
11. Inspect the caliper guide pin boot for proper seating
in the retaining groove of the guide pin and the
caliper mounting plate. Replace the caliper guide
pins or the guide pin boots, if corrosion or damage
exists. Refer to Brake Caliper Overhaul (Rear).
Installation Procedure
Important:
.. Install the inner pad with wear sensor near the
piston.
• Ensure that the wear sensor .is on the leading
edge of the inner pad during forward wheel
rotation. If the wear sensor is not on the leading
edge, use the other inner pad in the
replacement kit.
• Replace the inner and outer pads in axle sets only.
1. Install new inner and outer pads (2) into mounting
plate (1 ).
Disc Brakes 5-61
171937
221494
221494