Power Steering Reservoir Replacement; Off Vehicle (Cb Series); Power Steering Pump Flow Control - GMC chevrolet camaro 2000 Service Manual

2-24 Power Steering System
1
482358
482357
391544
Steering
Power Steering Reservoir Replacement -
Off Vehicle (CB Series) (
Disassembly Procedure
1. Place the hydraulic pump (1) on a fixed, flat
surface, with the shaft facing upward.
2. Insert a screwdriver into the retaining clip tab (3).
3. Using the screwdriver, force the retaining clip
tab (3) outward.
4. Slide the reservoir clip (4) away from the hydraulic
pump assembly (1 ).
5. Remove the reservoir (2) from the hydraulic pump
housing (1 ).
6. Remove the 0-ring seal from the neck of the
reservoir (2) or the hydraulic pump housing (1).
Discard the 0-ring seal.
Assembly Procedure
1 . Lubricate the new 0-ring seal with power ·
steering fluid.
2. Install the new 0-ring seal onto the neck of the
reservoir (2).
3. Install the reservoir (2) onto the hydraulic pump
assembly (1 ). Ensure the reservoir neck is
completely engaged onto the hydraulic pump
assembly (1 ).
4. Align the feet of the reservoir with the sides of the
hydraulic pump housing.
5. Install the new reservoir retaining clips (4)
(supplied with the pump). Ensure the retaining clip
tabs (3) fully engage with the hydraulic pump
housing (1 ).
Power Steering Pump Flow Control Valve
Replacement - Off Vehicle (Return Tube)
Disassembly Procedure
Important: Handle the pump with care. Do not carry
the hydraulic pump housing assembly (1) by the return
tube (2).
Important: Replace the hydraulic pump housing
assembly (1) if the return tube (2) is cracked or loose.
Do not attempt to repair the hydraulic pump housing
assembly (1 ).
1. Inspect the return tube (2) on hydraulic pump
housing assembly (1 ).
(