Park Brake Cable Replacement (Front) - GMC chevrolet camaro 2000 Service Manual

s~ss
Park, Brake
182184
Brakes
12. Rotate the adjuster arm toward the rear of the
vehicle and completely raise the park brake
lever (1 ).
13. Install the park brake adjuster spring (2).
14. Cycle the park brake lever 3 times.
15. Install the front floor console.
Park Brake Cable Replacement (Front)
Removal Procedure
Tool Required
J 37043 Parking Brake Cable Release Tool
Notice: Use care when performing service 'operations
on or around parking brake cables. Damage to the
(
plastic coating will reduce corrosion protection and if (
the damaged area .passes through the seal,
increased parking brake effort could re.suit Contacting
the coating with sharp-edged tools, or with sharp
surfaces of the vehicle underbody, should be avoided.
1. Ensure that the park brake hand lever is inthe
down position in order to disengage the ·
adjuster pawl.
2. Raise and suitably support the vehicle. Refer to
Lifting and Jacking the Vehicle in General
Information.
182210
3. Pull down on the front cable strand until the
214860
strand stops and stays extended: .
4. Remove the rear cables (2) from the equaiizer (3).
5. Use the J 37043 in order to remove .the fitting of
the park brake front cable from the bracket.