GMC chevrolet camaro 2000 Service Manual page 522

)
)
Brakes
Installation Procedure
1. Install the power brake booster onto the vehicle.
2. Install the brake booster pushrod (8) to the
brake pedal lever pin
(1 ).
2.1. Tilt the entire brake booster slightly in order
to work the brake booster pushrod onto the
brake pedal pin.
2.2. From inside the vehicle, install the brake
pedal pushrod washer (4) and retainer (7).
Notice: Refer to Fastener Notice in Cautions and
Notices.
3. Install the brake pedal nuts (3) attaching the brake
booster to the brake pedal with bracket (6).
Tighten
Tighten the brake pedal nuts to 20 N·m (15 lb ft)
in the following sequence:
3.1. Inboard upper
3.2. Outboard lower
3.3. Outboard upper
3.4. Inboard lower
4. On man.ual transmission equipped vehicles only,
install the clutch master cylinder nuts (7).
Tighten
Tighten the clutch master _cylinder nuts to
27 N·m (20 lb ft).
5. Install the master cylinder (6) onto the brake
booster (1 ).
6. Install the master cylinder nuts (7) attaching the
master cylinder to the brake booster.
Tighten
Tighten the brake master cylinder nuts to
29 N-m (21 lb ft)
7. Connect the vacuum hose (8) and the clamp (9)
to the check valve (10).
8. Install the left side instrument insulator. Refer to
Closeout/Insulator Panel Replacement - Left in
Instrument Panel, Gauges and Console.
9. Install the left side air inlet screen. Refer to Air
Inlet Grille Panel Replacement in Body Front End.
10. Install the hood rear seal. Refer to Seal
Replacement - Hood Rear in Body Front End.
11. Bleed the brakes. Refer to Hydraulic Brake
System Bleeding (Manual Bleeding) or Hydraulic
Brake System Bleeding (Pressure Bleeding).
Hydraulic Brakes 5-49
184982
8
9
10
1
2
6
5
4
184981