GMC chevrolet camaro 2000 Service Manual page 167

282946
282947
247323
Installation Procedure
1. Lightly coat th.e 0-rings with a mineral
base 525 viscosity refrigerant oil.
HVAC
2. install the orifice and the pressure sensor, if
replacing the tube.
3. Install new 0-rings.
4. Install the A/C evaporator tube to the vehicle.
Notice: Refer to Fastener Notice in Cautions
and Notices.
5. install the A/C evaporator tube bolt at the
condenser.
Tighten
Tighten the A/C evaporator tube bolt at the
condenser to 16 N·m (12 lb ft).
6. Install the A/C evaporator tube bolt at the module.
Tighten
Tighten the A/C evaporator tube bolt at the
module to 16 N·m (12 lb ft).
7. Connect the electrical connector at the
A/C refrigerant pressure sensor.
8. Recharge the A/C system. Refer to Refrigerant
Recov.ery and Recharging.
9. Perform a leak test on the A/C system. Refer to
Leak Testing.
Expansion (Orifice) Tube Filter.
Replacement
Removal Procedure
1. Recover the refrigerant. Refer to Refrigerant.
Recovery and Recharging.
2. Remove the air conditioning (A/C) evaporator.
Refer to Accumulator Replacement.
3. Remove the orifice from the A/C evaporator tube.
(