Turn Signal/Multifunction Lever; Turn And Lane-Change Signals - GMC 2008 Yukon Denali Owner's Manual

Turn Signal/Multifunction Lever

The lever on the left side of the steering column
includes the following:
G (Turn and Lane Change Signals): See Turn and
Lane-Change Signals on page 3-8.
53 (Headlamp High/Low-Beam Changer): See
Headlamp High/Low-Beam Changer on page 3-9.
Flash-to-Pass. See Flash-to-Pass on page 3-9.
N (Windshield Wipers): See Windshield Wipers on
page 3-10.
3-8
L (Windshield Washer): See Windshield Washer on
page 3-11.
5
(Rear Wiper Delay): See Rear Window
Wiper/Washer on page 3-12.
Z
(Rear Wiper): See Rear Window Wiper/Washer on
page 3-12.
= (Rear Wiper Wash): See Rear Window
Wiper/Washer on page 3-12.

Turn and Lane-Change Signals

The turn signal has two upward (for right) and two
downward (for left) positions. These positions allow you
to signal a turn or a lane change.
To signal a turn, move the lever all the way up or down.
When the turn is finished, the lever will return
automatically.
To signal a lane change, raise or lower the lever for less
than one second until the arrow starts to flash. This will
cause the turn signals to automatically flash three times.
It will flash six times if tow-haul mode is active. Holding
the turn signal lever for more than one second will cause
the turn signals to flash until you release the lever. The
lever will return by itself when it is released.